Introduction To The Use Of Shearing Machine
The use of the shearing machine is relatively simple. The thickness of the plate can be manually adjusted to control the gap between the blades. The foot switch can control the up and down. For those who want to achieve fully automatic adjustment, it can also be customized according to customer needs! If the plate cut by the shearing machine has burrs, you can check whether the blade is sharp or whether the gap is adjusted in place!
So how is the use of the shearing machine? As a Hunan shearing machine manufacturer that has been in business for many years, today I will give you a brief introduction to the method. When using the shearing machine, you must have professional personnel to conduct training before operating. The shearing machine cannot shear hardened steel and hard steel, high-speed steel, alloy steel, castings and non-metallic materials. In order to keep the blade edge sharp, the blade edge is blunt or damaged, it should be repaired or replaced in time, and overlapping shearing of different metal materials is not allowed. When shearing the plate, it is forbidden to put your hand under the pressure plate to operate. When cutting short materials, you should use another iron plate to press it down. When shearing materials, your fingers should be at least 200 mm away from the blade. After the pry bar is aligned, the pry bar should be withdrawn immediately before cutting. If the iron plate moves, wooden sleepers should be used to block it tightly to prevent the pry bar from popping out and injuring people after the pressure foot is pressed down. After the cut plates are stacked flat, they should be placed steadily, and the leftovers and waste materials should be cleaned up in time to keep the site clean.